Lifetime 6417 Use and Care Manual download pdf (Page 78)

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE

SEC

AGB

Top

Exterior View

AGBY

Top

AHB

Exterior View

AHIY

(Not to scale)

DOMED SKYLIGHT ASSEMBLY

SEC

Use a plain screwdriver to gently remove any excess plastic from the twelve holes in the Roof Panel for Domed

Skylight (AHB). It’s important that the hole stay square; try not to round the corners of the edges of the holes. Stick the end

of the Butyl Tape (AHI) over the groove and top, left hole of the Roof Panel for Domed Skylight as indicated below.

Move to the right and over the groove covering all the holes along the top of the opening. Once the top, right

corner and hole are covered, cut the Butyl Tape. Run your ﬁ nger along the paper backing pressing down

slightly to remove any gaps or bubbles between the Butyl Tape and the groove. Remove the paper backing from

the piece of Butyl Tape you just applied. Overlap the end of the roll of Butyl Tape with the end you just cut and

apply the Butyl Tape over the holes along the groove on the right of the opening. Continue applying the Butyl

Tape in this fashion until all holes have been covered and the ends overlap.

Groove along grayed area

Remove the protective plastic ﬁ lm from both sides of the Domed Skylight (AGB). Carefully align the holes in the

Domed Skylight with those in the Butyl Tape. Set the Domed Skylight over the opening in the Roof Panel for

Domed Skylight. Press down and verify there are no gaps or bubbles between the Butyl Tape and the Domed

Skylight.

Note: Use a screwdriver to remove any excess plastic from all

holes in Panel.

Note: Butyl Tape must cover all twelve holes.

12.1

12.2

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 103 104

No comments

Lifetime 6417 Use and Care Manual Page 78